Tel.: +49 (0)6145/503-0
Contact

 
 

Parts conveyor drive

AViTEQ parts conveyors for ordered arranging, individualizing and conveying are used in every case where mass parts have to be supplied to a magazine, a machine or to installation equipment, item for item, with a pre-determined orientation and time. 

Advantages and benefits 

  • High level of conveying capacity with compact dimensions
  • operationally safe in continuous employment
  • synchronized two-mass vibration system
  • no influencing of the vibration characteristics through the weight of the parts being conveyed
  • maintenance-free drive
  • conformity with all EC Guideline which affect the drives
  • also available for explosion-endangered spaces (Ex), as well as for 60 Hz power systems and other mains voltages

Bowl and drive selection

The normal shape of the bowls is cylindrical, in certain cases also cone or step-shaped. Such a bowl is selected if parts tend to become jammed between spiral paths located over one another. The selection of the pot diameter depends of the size of the parts to be conveyed. As a rule, it can be assumed that the largest dimension of the part should not exceed approx. 1/6 of the pot base diameter. With this, the drive is also virtually determined. The replacement of pots with similar diameter, however, with different weight is easily possible. For this, corrections are to be carried out on the compensation weights according to operating instructions. Stainless steel (1.4301; 1.4404) is employed as a material for the parts conveyor pots. Pots with 100 mm diameter are additionally produced from polyamide or aluminum. According to requirement, the pots can be provided with different linings, such as e.g. polyurethane, conveying brush material or Teflon. 

Accessories

AViTEQ controller

Product photos

 

Brochures

Teilefördergeräte TF (DE) - PDF (570kB)